7-10
CARBURETORS
CARB
NOTE:
EAS00495
MEASURING AND ADJUSTING THE FUEL
LEVEL
1. Measure:
fuel level
a
Out of specification
Adjust.
Fuel level (below the line on the
float chamber)
3.0
4.0 mm
a. Stand the motorcycle on a level surface.
b. Place the motorcycle on a suitable stand to
ensure that the motorcycle is standing
straight up.
c. Install the fuel level gauge
1
to the fuel drain
pipe
2
.
Fuel level gauge
90890-01312
d. Loosen the fuel drain screw.
e. Hold the fuel level gauge vertically next to the
line on the float chamber
3
.
f. Measure the fuel level
a
on both sides of the
carburetor assembly.
The fuel level readings should be equal on both
sides.
2. Adjust:
fuel level
a. Remove the carburetor assembly.
b. Check the needle valve seat and needle
valve.
c. If either is worn, replace them as a set.
d. If both are fine, adjust the float level by slight-
ly bending the float tang
1
.
e. Install the carburetor assembly.
f. Measure the fuel level again.
g. Repeat steps (a) to (f) until the fuel level is
within specification.
Summary of Contents for FZS1000(N) 2001
