Operation
52
EMU37323
Checking the fuel filter
Check that the fuel filter is clean and free of
water. If any water is found in the fuel, or if a
significant amount of debris is found, the fuel
tank should be checked and cleaned by a
Yamaha dealer.
EMU36903
Controls
Tiller handle models:
z
Move the tiller handle fully to the left and
right to make sure operation is smooth.
z
Turn the throttle grip from the fully closed
to the fully open position. Make sure that it
turns smoothly and that it completely re-
turns to the fully closed position.
z
Look for loose or damaged connections of
the throttle and shift cables.
Remote control models:
z
Turn the steering wheel full-right and full-
left. Make sure operation is smooth and un-
restricted throughout the whole range with
no binding or excessive free play.
z
Operate the throttle levers several times to
make sure there is no hesitation in their
travel. Operation should be smooth over
the complete range of motion, and each le-
ver should return completely to the idle po-
sition.
z
Look for loose or damaged connections of
the throttle and shift cables.
EMU36484
Engine shut-off cord (lanyard)
Inspect the engine shut-off cord and clip for
damage, such as cuts, breaks, and wear.
EMU40994
Engine oil
1.
Place the outboard motor in a vertical
position (not tilted).
NOTICE:
If the out-
board motor is not level, the oil level
indicated on the oil dipstick may not
be accurate.
[ECM01862]
2.
Remove the oil dipstick and wipe it
clean.
3.
Insert the oil dipstick completely and re-
move it again.
1. Fuel filter
1
ZMU08691
1. Clip
2. Engine shut-off cord (lanyard)
1. Oil dipstick
ZMU06873
1
2
1
ZMU08692
©
2019 Yamaha Motor Corporation, U.S.A.
