CVP-809/CVP-805 Owner’s Manual
114
2
Attach the three legs and three leg beams.
Refer to the diagram below to verify the orientation of the
legs.
1
Install and tighten four screws on each leg, starting with
one of the front legs.
2
Slide the leg beams over the legs, and attach them to each of
the legs using four thin screws (4 x 10 mm).
Make sure that the gradually inclined side of the leg beams
faces the inside of the unit as shown.
3
Attach the lyre braces.
1
Attach the lyre braces using the four thin screws (4 x 16
mm).
4
Raise the unit to the standing position.
Use the front legs as support to raise the unit.
Rear leg
Front leg
Front leg
6 x 40 mm fixing screws
The gradually
inclined side faces
the inside.
4 × 10 mm
thin screws
1
4 x 16 mm
thin screws