Yamaha AVENTAGE RX-A1060, Owner'S Manual

Page: 21 / 190

En
21
Connection diagram
Refer to the following diagram and connect the speakers to the unit.
Y
When using only one surround back speaker, connect it to the SINGLE jack (L side).
Connecting speaker cables
Speaker cables have two wires. One is for connecting the negative (-) terminal of the unit and
the speaker, and the other is for the positive (+) terminal. If the wires are colored to prevent
confusion, connect the black wire to the negative and the other wire to the positive terminal.
1
Remove approximately 10 mm (3/8”) of insulation from the ends of the speaker cable, and
twist the bare wires of the cable firmly together.
2
Loosen the speaker terminal.
3
Insert the bare wires of the cable into the gap on the side (upper right or bottom left) of the
terminal.
4
Tighten the terminal.
Using a banana plug
(U.S.A., Canada, China, Australia, Brazil and General models only)
1
Tighten the speaker terminal.
2
Insert a banana plug into the end of the terminal.
Connecting the subwoofer (with built-in amplifier)
Use an audio pin cable to connect the subwoofer.
1
2
ZONE OUT
ZONE 2
SPEAKERS
CENTER FRONT SURROUND BACK SURROUND F.PRESENCE
R L R R R L L L
ZONE 2
SINGLE
ZONE 2/BI-AMP
PRE OUT
SUBWOOFER CENTER FRONT SURROUND SUR. BACK
(SINGLE)
EXTRA SP1 EXTRA SP2
1
6 7
2
3
4 5
9 9
E R
The unit (rear)
FR
ONT
+
1 1
2 2
4 4
3 3
+ (red)
– (black)
FR
ONT
+
1 1
2 2
Banana plug
(SINGLE
)
SUBW
OOFER
PRE OUT
CENTER
SUR.
BACK
SURR
UND
1
2
SURR
OUND B
ACK
L
Audio pin cable