9
Cooling water pressure display
(optional: cooling water pressure sensor
has been installed)
The cooling water pressure indicator (
)
comes on and the cooling water pressure is
shown in 5 levels. You can select whether to
display the scale.
CAUTION:
• When the cooling water pressure
decreases to 10 psi or less, turn the
engine off and check the cooling water
inlet for clogs.
• If you cannot locate and correct the
cause, consult a Yamaha dealer.
NOTE:
The cooling water pressure level display
shows “L” for low and “H” for high.
Water detection warning
When water has accumulated in the water
separator (fuel filter), the water detection
warning indicator (
) and the “WATER IN
FUEL” warning blink. This function is not
available for outboard motors that are not
equipped with the water detection warning
function.
CAUTION:
When the water detection warning comes
on, turn the engine off and remove the
water from the water separator (fuel fil-
ter) by following the procedure described
in the Owner’s Manual of the outboard
motor. A malfunction can result if fuel
mixed with water is sent to the engine.
NOTE:
or
: To deactivate the buzzer
and return to the display before the warning
was activated.
10 PSi
Blink
Cooling water pressure display/Water detection warning
