Yamaha 60F, Supplementary Service Manual

Page: 53 / 304

– 39 –
E
INSP
ADJ
FUEL SYSTEM/CONTROL SYSTEM
3. Fill:
• Gear oil
Filling steps
(1) Insert the gear oil tube into the drain
hole and slowly fill the gear oil until oil
flows out of the check hole.
(2) Install the gear oil level check screw
and then quickly install the gear oil
drain screw.
NOTE:
The gear oil level should be about 13 mm
(0.51 in)
a
below the mating surface of the
mechanical fuel pump body and its cover.
4. Install:
• Flywheel magnet assembly cover
CONTROL SYSTEM
ADJUSTING THE THROTTLE
POSITION SENSOR
1. Measure:
• Throttle position sensor output voltage
(with the throttle valves fully closed)
Out of specification
→
Adjust.
NOTE:
• Be sure to adjust the throttle valve’s open-
ing before measuring the throttle position
sensor output voltage.
• When measuring the throttle position
sensor output voltage, set the digital
tester to the manual range.
Recommended gear oil
GEAR CASE LUBE (USA) or
Hypoid gear oil SAE 90
Total amount
47 - 53 cm
3
(1.59 - 1.79 US oz,
1.66 - 1.87 Imp oz)
Throttle position sensor output
voltage (pink (P) – orange (O))
Z150, Z175: 0.58
±
0.02 V
Z200 (L): 0.60
±
0.02 V
Z200 (X): 0.62
±
0.02 V
3080
1
a
3060