Yamaha 50G, Service Manual

Page: 47 / 204

3-12
INSP
ADJ
E
PERIODIC SERVICE
D34300-1
OIL PUMP LINK ADJUSTMENT
1. Fully-open the carburetor throttle valve.
2. Set the oil-pump lever 1 mm off full-
open side stopper. With the lever in this
position, adjust the length of the rod
connecting the oil-pump to the carbure-
tor and tighten the locknut.
3. Install the connecting-rod.
4. By operating the carburetor, check that
the throttle-valve opens fully.
D34600-0
POWER TRIM AND TILT FLUID
(PTT model)
1. Tilt-up the motor and lock it with the tilt-
lock lever.
2. Remove the fluid-level plug to check the
fluid level. With the motor tilted-up, the
fluid level should be immediately below
the fluid-hole. If the fluid level is low,
top up with the recommended fluid.
CAUTION:
When checking the fluid level (with the unit
removed from the engine), hold the unit in
the vertical position and set the tilt-rod in
the tilt-up position.
3. Re-fit the fluid-level plug and tighten it.
ATF
(automatic transmission fluid)
T
R
.
.
Fluid-level plug:
Short transom [6H308]:
3 Nm (0.3 m • kg, 2.2 ft • lb)
Long transom [6H1-15, 62F-02]:
7 Nm (0.7 m • kg, 5.1 ft • lb)