Yamaha 2014 MT-07, Service Manual

Page: 261 / 564

CHAIN DRIVE
4-106
4. Fit the space “a” between the side plates of
the drive chain “1” onto the rib “b” on the drive
chain guide “2”.
5. Install:
• Shift arm “1”
• Shift rod joint
• Shift rod
• Shift rod locknuts
TIP
Before installing, make sure to align the mark “a”
of the shift shaft with the punch mark “b” of the
shift arm.
6. Measure:
• Installed shift rod length “a” and “b”
Incorrect
→
Adjust.
7. Adjust:
• Installed shift rod length
▼▼▼ ▼ ▼ ▼▼▼ ▼ ▼ ▼▼▼ ▼ ▼ ▼▼▼ ▼ ▼ ▼▼▼ ▼ ▼ ▼▼▼ ▼ ▼▼▼
a. Loosen both locknuts “1”.
TIP
The shift rod locknut (shift pedal side) has left-
hand threads.
b. Turn the shift rod “2” in direction “a” or “b” to
obtain the correct shift pedal position.
c. Tighten both locknuts.
TIP
The shift rod locknut (shift pedal side) has left-
hand threads.
d. Make sure the installed shift rod length is
within specification. Make sure that the in-
stalled shift rod length is within specification
and that the angle between the shift arm and
the shift rod is 90°.
T
R
.
.
Shift arm pinch bolt
14 Nm (1.4 m·kgf, 10 ft·lbf)
Installed length “a”
217.5–219.5 mm (8.56–8.64 in)
Installed length “b”
35.0–36.0 mm (1.38–1.42 in)
1
b
a
2
b
1
a
Direction “a”
Installed shift rod length increases.
Direction “b”
Installed shift rod length decreases.
T
R
.
.
Shift rod locknut (shift arm side)
9 Nm (0.9 m·kgf, 6.5 ft·lbf)
Shift rod locknut (shift pedal
side)
9 Nm (0.9 m·kgf, 6.5 ft·lbf)
Left-hand threads
a
b
1
2
a
b