Yamaha 2014 MT-07, Service Manual

Page: 240 / 564

FRONT FORK
4-85
TIP
Make sure that the O-ring contacts the top of the
lower bracket “3”.
2. Install:
• Front fork cover “1”
• Upper bracket “2”
TIP
• Before installing the upper bracket, remove
any grease from the outer surface “a” of the
cap nut.
• Make sure the inner tube end is flush with the
top of the upper bracket.
3. Tighten:
• Lower bracket pinch bolts
• Upper bracket pinch bolt (center)
• Upper bracket pinch bolts (left and right)
• Front fork cap bolt
4. Install:
• Front fender brackets “1”
TIP
Temporarily tighten the front fender bracket
bolts “2”. Then, while pushing the bottom of each
front fender bracket in the direction shown in the
illustration, tighten the front fender bracket bolts
to specification.
5. Install:
• Front fender
• Front fender side cover “1”
▼▼▼ ▼ ▼ ▼▼▼ ▼ ▼ ▼▼▼ ▼ ▼ ▼▼▼ ▼ ▼ ▼▼▼ ▼ ▼ ▼▼▼ ▼ ▼▼▼
a. Fit the projections “a” on the front fender side
cover into the holes “b” in the front fender,
and then slide the cover rearward.
b. Fit the projection “c” on the front fender side
cover into the hole “d” in the front fender.
c. Install the front fender side cover bolt, and
then tighten the bolts to specification.
2
1
3
a
2
2
1
T
R
.
.
Lower bracket pinch bolt
23 Nm (2.3 m·kgf, 17 ft·lbf)
Upper bracket pinch bolt (center)
21 Nm (2.1 m·kgf, 15 ft·lbf)
Upper bracket pinch bolt (left and
right)
26 Nm (2.6 m·kgf, 19 ft·lbf)
Front fork cap bolt
23 Nm (2.3 m·kgf, 17 ft·lbf)
T
R
.
.
Front fender bracket bolt
7 Nm (0.7 m·kgf, 5.1 ft·lbf)
T
R
.
.
Front fender bolt (upper side)
7 Nm (0.7 m·kgf, 5.1 ft·lbf)
LOCTITE®
Front fender bolt (lower side)
7 Nm (0.7 m·kgf, 5.1 ft·lbf)
T
R
.
.
Front fender side cover bolt
7 Nm (0.7 m·kgf, 5.1 ft·lbf)
1
2