Yamaha 2007 FZ6-NA, Service Manual

Page: 17 / 538

FEATURES
1-8
If any of the immobilizer system circuits are
defective, the immobilizer system indicator
light will flash, and then the display will indicate
a two-digit error code (e.g., 51, 52, 53).
NOTE:
If the display indicates error code 52, this could
be caused by transponder interference. If this
error code appears, try the following.
1 Use the code re-registering key to start the
engine.
NOTE:
Make sure there are no other immobilizer keys
close to the main switch, and do not keep more
than one immobilizer key on the same key ring!
Immobilizer system keys may cause signal
interference, which may prevent the engine
from starting
2 If the engine starts, turn it off and try starting
the engine with the standard keys.
3 If one or both of the standard keys do not
start the engine, take the vehicle, the code
re-registering key and both standard keys to
a Yamaha dealer and have the standard keys
re-registered.
If the display indicates any error codes, note
the code number, and then have a Yamaha
dealer check the vehicle.
CAUTION:
ECA4S81010
If the display indicates an error code, the
vehicle should be checked as soon as pos-
sible in order to avoid engine damage.
LCD and tachometer brightness control mode
(FZ6-NHG(W)/FZ6-NAHG/FZ6-SHG(W)/FZ6-
SAHG)
This function allows you to adjust the bright-
ness of the LCD and the tachometer panel and
needle to suit the outside lighting conditions.
To set the brightness
1 Turn the key to “OFF”.
2 Push and hold the “SELECT” button.
3 Turn the key to “ON”, and then release the
“SELECT” button after five seconds.
4 Push the “RESET” button to select the
desired brightness level.
5 Push the “SELECT” button to confirm the
selected brightness level. The display will
return to the odometer or tripmeter mode.
1. Tachometer panel
2. Tachometer needle
3. LCD
4. Brightness level