Installation manual for the Electronicbox, version D
No time for manuals? No problem, this will take only 3 minutes of your time to read it and you will have more fun while the
installation of your new D-Box.
Push button or switch input for the left flashers (orange):
You can use this input for a push button or a switch what
will connect the input to ground / chassis when pressed. An closed contact will start the flasher left.
Push button or switch input for the right flashers (purple / violet):
You can use this input for a push button or a
switch what will connect the input to ground / chassis when pressed. An closed contact will start the flasher output right.
An emergency flasher function
is active by pressing both direction buttons. This function is only enabled in the "button
mode" for the flasher section.
Push button for the horn function (thin red):
The horn will work when the button is pressed and the input cable is
connected to ground via the button.
Button or Switch input for the headlight (brown):
The headlight will toggle between high - and low beam when the
button is pressed and the input cable is connected to ground.
Button input for the start relay (yellow):
The relay output will switch the 12 volt for the starter relay when the button is
pressed and the input cable is connected to ground.
Button input for engine stop (blue):
This is the connection for the engine stop function. A press on the button will
switch off the 12 Volt power from the D-Box to the ignition for 2 seconds.
Brake light switch (green):
You can connect your brake light switch(es) to this cable and control your brake light or rear
light with this input.
Ground (black):
Just connect the black cable direct to the chassis and make a connection from this point to the buttons
of the handle bar. It is important that the handle bar have the same ground connection, Otherwise the box might make
some "funny" mistakes due to a poor grounding of the handle bar when a button is pressed.
Output low beam:
This is the 12 Volt output for the low beam headlight. However, the light can be switched off when
pressing the "start" button in order to have enough energy for the starter (further infos at page 2, "setup").
Output high beam:
This is the 12 Volt output for the high beam bulb.
Output horn:
This is the 12 Volt output to the horn, what is active by a button press.
Be careful,
t
his output can control
modern horns with maximum 3 Ampere. Every current above this value might destroy this output.
Flasher outputs left and right:
These are the 12 Volt power outputs to the turn signals. However, the flasher frequency
is independent of the load. So, problems with led flashers are a matter of the past.
Output start relay:
This output is connected to the
start relay and
not
direct to the starter. You know that the small D -
Box can not handle direct 100 Ampere for the starter and will need a starter relay ;-) .
Output brake light / rear light:
This output is connected to the brake light. You can use this cable for the rear light as
well if you switch on the mode option 5 (see page 2).
12 V Output to ignition:
This output is connected with the ignition. A press on the stop button will disconnect the ignition
for 2 seconds.
1 / 2