SPEC
17
The coupler for the air induction
solenoid lead and camshaft
sensor lead should be con-
nected above the ignition coil
sub wire harness and it should
not drop on the cylinder head
cover behind the ignition coil.
Pass the right handlebar switch
lead between the frame and
heat protector.
Coolant reservoir tank drain
hose should cross with the
speed sensor lead under the
swingarm bracket. Route the
coolant reservoir tank drain
hose over the up side of the
vehicle.
Pass the rear brake light switch
lead between the swingarm
bracket and coolant reservoir
tank.
Release the tip of the clamp and
install it to the clutch cable.
Insert the clamp to the hole
located on the right back side of
the radiator.
Radiator fan motor lead should
not be caught while inserting
the clamp.
Push the clamp until it hits the
radiator side stay. Radiator fan
motor lead should not be
caught.
Clamp the clutch cable so that it
is within this specified clamp.
CABLE ROUTING