Yamaha 01x, Service Manual

Page: 102 / 153

102
O1X
■
DISPLAY MESSAGES
Messages
*** SURE?
---- (Channel number “flashes” alternately with “----”)
Do you want to initialize backup data?
ERROR: Backup Data Crashed!!
Do you want to initialize backup data?
EXECUTING BACKUP. PLEASE KEEP POWER ON...
INCORRECT WORDCLOCK!
Initializing backup data, please keep power on ...
LIBRARY: CATEGORY CONFLICT!
LIBRARY: FOR EFFECT1 ONLY!
LIBRARY: INVALID CHANNEL!
LIBRARY: NO DATA!
LIBRARY: PROTECTED!
LIBRARY: READ ONLY!
mLAN MASTER NOW!
mLAN SLAVE NOW!
MLAN1/4/5: TX BUFFER FULL!
MLAN1/4/5: RX BUFFER FULL!
NOT AUTO WORDCLOCK MODE NOW!
NOT DEFINED.
RELEASE PAIR?
SYSTEM BACKUP OK?
UNLOCK (NO SIGNAL) NOW!
Information
This prompt asks if you want to execute the operation, or change the setting (Final
confirmation).
These channels cannot be used while 01X is set to 96kHz/88.2kHz operation.
This prompt asks if you want to initialize the backup data.
Because the power was turned off while data was being written to Flash ROM
(during a “Please keep power on” message), the backup data must be initialized.
The prompt asks if you want to initialize the backup data.
Never attempt to turn off the power while data is being written to Flash ROM.
Turning the power off in this state results in loss of all user data and may cause the
system to freeze (due to corruption of data in the Flash ROM).
An inappropriate wordclock is being received from the connected device to which
you are synchronizing.
The Factory Set operation is being executed. Never attempt to turn off the power
while data is being written to Flash ROM. Turning the power off in this state
results in loss of all user data and may cause the system to freeze (due to corruption
of data in the Flash ROM).
The channel categories (e.g., Input , Aux Out, etc.) of the original recall/store
destination do not match.
Not available for Effect 2
You can recall or store settings for this channel.
The selected region does not contain data.
Can’t save, erase, or edit the title because the song is protected.
Can’t save, erase, or edit the title because the song is read-only.
This operation cannot be performed because the 01X is in mLAN Master mode.
This operation cannot be performed because the 01X is in mLAN Slave mode.
Failed to process the MIDI data because too much data was received/transmitted
at once.
The mLAN auto wordclock setting is invalid.
Not available for this channel.
This prompt asks if you want to release the pair setting.
This prompt asks if you want to execute System Backup.
This cannot be selected as the wordclock source.