Yale GDP040-070VX, Operating Manual

Page: 182 / 204

3. Turn over the rim and tire. Put
blocks under the rim so that the rim
is 8 to 10 cm (3 to 4 in.) above the
floor. Install the flange seat (if used)
and the lock ring.
4. Put the lock ring in the correct
position on the rim. Add air pres-
sure to the tire as described in
Add Air to Pneumatic Tires
With Tube
.
Tire Installation, Two-Piece
Wheel
CAUTION
Do not use pneumatic-shaped,
solid tires on two-piece bolt
together drive wheels. Spin-
ning may occur.
1. Install the inner tube and the
rubber flap in the tire. Install both
halves of the wheel rim in the tire.
Make sure the stem of the inner
tube is aligned with the slot in the
rim.
2. Tighten the nuts that hold the
rim halves together to 175 N•m
(130 lbf ft). Add air pressure to
the tire as described in
Add Air
to Pneumatic Tires With Tube .
Add Air to Pneumatic
Tires With Tube
WARNING
Add air pressure to the tires only in a safety cage. See
Figure 40. Inspect the safety cage for damage before use.
When air pressure is added, use a chuck that fastens
onto the valve stem of the inner tube. Make sure there is
enough hose to permit the operation to stand away from
the safety cage when air pressure is added to the tire.
Maintenance
180