Tracks
1030988F-1/9
TOOLS REQUIRED:
adjustable end wrench
1/2” wrench
1/8” Allen wrench
center punch
hammer
electric drill
1/8” drill bit
9/32” drill bit
touch-up paint
Place both tracks on the
roof. Carefully select their
locations, making sure
they are aligned with each
other and symmetrical on
the vehicle. Carefully hold
the tracks in place with
masking tape.
Remove both
tracks.
ATTENTION INSTALLERS:
If you will be installing tracks on several vehicles,
call for information on industrial grade installation tools.
YAKIMA CUSTOMER SERVICE: 888-925-4621
InstRuCtIon PaRt #1030988 Rev.F
Read yellow caution
page before you begin.
Clean
vehicle’s
roof before
you begin.
Do not DRILL DeePeR tHan 1/4”. use a drill
stop to prevent drilling through vehicle’s interior
liner. If you do not have a stop, use tape and
mark bit 1/4” from tip.
Wear goggles
when drilling!
For both tracks, first,
drill 1/8” pilot holes.
next, drill
9/32” hole.
Carefully blow
away debris.
seal edges
of holes with
enamel base
paint. allow
to dry.
attach nut with
washer onto
Plusnut® tool.
Punch center of marks
to prepare for drilling.
attach
soft rubber
washers onto
Plusnuts®.
note: Washer
should be
flat against
Plusnut® head.
attach Plusnut®
and washer
to tool
as shown.
track base is loose and can slide.
Be sure it is aligned to track.
outline rear holes through
both tracks.