M4
CLIP
SAFETY
CHECK
• DO THIS FOR EACH CLIP.
• If clip moves, open cover and tighten
screw.
Close cover and check clip
again.
• If it still moves, check M1 mea-
surement
in Step 3 and re-tighten.
• Gold sliders should be an equal distance
from the slider marks on each tower
.
• IF the gold sliders are not equal
distances,
loosen or tighten screws until
sliders are equal.
F
INE
T
UNING
THE
T
OWER
TENSION
:
CONGRATULATIONS!
Now you can enjoy
your favorite adventures made convenient
by your durable Yakima Rack!
WITH DOORS OPEN, CHECK BOTH TOWERS:
• GRAB BAR on inside of Towers, push & pull
(use arm strength, full body strength not
necessary). Tower should not move.
• IF TOWERS MOVE, tighten screws slightly.
• KEEP SLIDER MARKS EQUAL.
• CLOSE COVER & CHECK AGAIN —
If towers move, check measurements again.
A
TTACH
R
EAR
R
ACK
: R
EPEAT
S
TEPS
9
THROUGH
14
• Use “M4” measurement
from list in clip box.
• MEASURE FROM CENTER OF EACH BAR.
• REPEAT SAFETY CHECK in steps 13 & 14 .
SAFETY CHECK
PULL Clips, GRAB Bars
TO REMOVE RACK:
• Open tower covers & lift rack
up and off (do NOT
disassemble).
TO RE-INSTALL:
• Place Towers (covers open)
in original positions.
• Close Tower covers &
recheck rack and clips (Steps
13 & 14). Tighten if needed.
Other Information:
• SKS
®
Lock Cores
: Follow
directions and install with
Tower covers closed.
• To secure long loads
:
Use tie-downs at front
and rear of vehicle.
• Line front & back of clips
with
black vinyl liners;
trim if necessary.
• Slip lined clip
into Tower
through slits
on side.
I
NSTALL
C
LIPS
:
I
NSTALL
L
OCK
H
OLDER
& B
RASS
F
ASTENER
:
S
ECURE
THE
RACK
TO
C
AR
’
S
ROOF
:
• Tighten one side slightly
so that cam
cover closes with light pressure—and
without moving the tower. Do not
overtighten.
Close cover.
• Go to opposite side,
tighten screw
slightly, close cover.
• Insert lock holder into holes in
Clip & Tower, matching notches.
• Push brass fastener
over lock
holder. It should feel snug.
• Repeat steps 9 & 10
for other
Tower.
Check clip
instructions in
clip box for
special NOTES
that may apply
to your car.
ATTACH RACK TO CAR
– KEEP SLIDER MARKS EQUAL –
The gold sliders may
fall below or cover up
slider marks
depending on the
make of car.
NOTE:
The gold slider
should NEVER
TOUCH the
crossbar.
• Tighten each side as evenly as
possible
—a few turns on one tower,
then a few on the other. Open and
close cam covers with each
adjustment.
• Tighten until the covers close
firmly
—with some resistance.
This needs to be done gradually
to prevent the towers from
moving off center.
WITH DOORS OPEN:
• PULL
each clip away from car—
PULL HARD!
TOWER
SAFETY
CHECK
Summary of Contents for Q towers
Page 10: ...M3 M2 M1...
Page 11: ...M4...