ATTACH THE KNOBS:
Engage the threads of the
bolts.
T-BOLT IS LOCKED
when the “T” of the
bolt is turned inside
the hole:
TIGHTEN
THE KNOBS.
SECURE THE
BASKET TO
THE BARS.
Lock the T-Bolts.
ATTACH BOLTS.
Insert bolt into round hole,
and T-bolt into slotted hole.
REFER TO THE DRAWINGS BELOW
FOR BAR PLACEMENT,
or to
determine if the bar is
required.
ATTACH LOAD BAR.
With a washer on the bolt, align the end
clamps to the hole in the bar. Thread the bolts
into the embedded nuts.
DO NOT COVER
JOINT SCREWS
WITH END
CLAMPS.
Tighten bolts
while pushing
the end clamps
together.
BIKES
BOATS
SKIS
Long loads may interfere with LoadBar.
• Attach carrier at front of
basket and to load bar.
• Adjust the bar for load
stability.
• For shorter boats, attach accessory at front
of basket and to load bar.
• Longer loads, such as canoes or sea kayaks,
require the load bar to be removed.
• Attach accessory at
front of basket and to
load bar.
On some
vehicles, hatch
interference is
unavoidable.
USE CAUTION
WHEN OPENING
YOUR HATCH.
CHECK INSTALLATION:
Make sure installation is secure
by tugging at basket.
TO REMOVE THE BASKET, DO NOT
DISASSEMBLE THE HARDWARE.
• Loosen the knobs until barely
attached.
• Unlock the T-bolts and let curved
brackets swing freely.
• Remove basket.
The basket should NOT
SLIDE on the bars.
Tighten knobs.
Always tie down
long loads to
front and rear of
vehicle.
ACCESSORIES MUST BE ATTACHED TO THE FRONT OF THE BASKET (FRONT OF VEHICLE).
