Instruction #1036004A - Page 2 of 9
3
4
5
INSTALL THE
ADAPTERS.
INSTALL THE BRACKET AND PLATES.
BACK OUT BOLTS AND RELEASE STRAPS.
2X
2X
Squeeze
and pull to
remove the
covers.
Use the 4mm
torque wrench
supplied with your
TimberLine towers
to loosen the
upper adjustment
screw 8 turns.
Using the torque wrench or a cordless
drill, loosen the lower adjustment screw
on each tower about 50 turns until the
straps can be lifted out of the cradle.
Press against the backside of the strap
and lift out of the cradle as shown.
“Snap”
3.5 Nm
“Click!”
“Click!”
“Click!”
“Click!”
“Click!”
“Click!”
3.5 Nm
Install the bracket from your LockNLoad Platform,
the plate, and nut insert as shown. Tighten the
bottom screw and the upper front adjustment
screw to 3.5 Nm using the torque wrench.
Snap the
adapters
into place.
7,0%(5/,1(,167$//$7,21Ă,167$//$7,217,0%(5/,1(Ă7,0%(5/,1(,167$/$&,1
8X
2
LOOSEN THE ADJUSTMENT SCREW.
2X
1
REMOVE COVERS.
2X
2X
Vehicles with curved raised rails may require more pitch adjustment. Assess your
vehicle beforehand and do not use the plates in TimberLine step 5 if necessary.
