1033386A - 2/12
place a set of towers with bars on your car’s rack.
do noT insTaLL
ToWEr dirECTLY oVEr
FaCTorY Crossbar
push end
caps onto the
ends of the
crossbars.
aTTaCh ToWErs To Crossbar
opEn and roTaTE
LEVEr to loosen the
rail hooks.
You may need to move the factory
crossbar if there is any interference
with the towers.
pull against the back of the tower to seat the
tower on the rail.
On a level surface, insert bar through tower.
open bolt cover to
reveal tower bolt.
Loosen tower
bolt with
wrench.
• Position towers at
equal distances.
• Center the bar on
the towers.
ON SOME WIDE RAILS:
It may be necessary
to loosen the lever to
allow the hooks to
engage the rail.
Lift the rubber flap to see
if the rail is seated into
the curve of the tower.
Minimize the gap, until the tower is tight
against the rail.
Be careful to keep the bars horizontal; the loose towers could slide off bar.
