Instruction #1036055A-2/9
4X
❶
➋
4X
❸
First look up your vehicle online at yakimatech.com. You will find hardware and base
pads specific to your vehicle listed in the measurements section or fit notes section.
These will be the parts used for installation. Use this worksheet to check off which are
required for your vehicle.
Open the cover-plates.
Thoroughly clean
your vehicle’s roof.
Consult your vehicle’s owner’s
manual to determine how your
cover plates are opened or
removed. This will vary from
vehicle to vehicle.
M7 X 30mm
hardware
M7 X 50mm
hardware
stepped pad
flat pad
HARDWARE
FLAT PAD
FLAT PAD
PADS
STEPPED PAD
Prepare threads.
Be sure the threads are clear of
paint by carefully threading your
fastener in and out of the hole a
few times while blowing away any
debris that accumulates.
NOTE: If there are multiple holes in
the front pocket, use the forward-
most holes. Use the rear-most in
the rear pockets to gain maximum
crossbar spread.
NOTE: Some vehicles have
a plug in the threads which
must be removed.
