Instruction #1036057B - Page 5 of 11
DRILL A HOLE THROUGH THE WEATHER-STRIPPING.
APPLY SILICONE TO THE HOLES.
INSTALL THE WEATHER-STRIPPING.
INSTALL THE PAD AND BASE.
INSTALL THE WASHER AND SCREW.
9
10
11
12
13
Find the puncture you made
in step 8 on the weather-
stripping and use a drill to
drill a 3/8” hole through the
weather-stripping.
•
Remove the center punch from the hole.
•
Generously apply the silicone into the
hole and fill it until it mounds up slightly
above the surface.
•
Remove the masking tape
you installed in steps 3
and 4 from the weather-
stripping and your vehicle.
•
Carefully align and install
the weather-stripping.
•
Press the end piece back
into place making sure it is
properly seated.
•
Install a pad over
the hole in the
weather-stripping
being sure to
orient it as shown.
•
Install a base over
the pad.
•
Use the wrench to install a
washer and screw being sure
to install the washer convex
side down as shown.
•
Tighten until snug but do not
fullly tighten the screw yet.
2X
2X
WARNING:
If you do not adequately apply
the silicone sealant to the holes then water
from outside of the vehicle will enter the cab.
NOTE:
You may notice a
gap between the pad and
the vehicle at the front.
This is normal and will
vary depending on vehicle.
end piece
pièce d'extrémité
sección final
convex
convexe
convexo
2X
2X
REPEAT THE PROCESS FOR THE PASSENGER SIDE.
14
Use steps 1 through 13 as a guide to modify the passenger side weather-stripping and
install the landing pads in the same manner that you just performed for the driver side.
