How to Replace New Label Roll
Please replace new label roll as follows.
When you take the last label on the sensor with setting Auto Mode, Feed
Roller will stop and LED will be flashing.
Feed Roller will stop after few second when it is no label on the sensor.
In the case of setting the same label roll
■
Keep pressing FWD BUTTON in order to wind new label roll into Backing
Paper Release Bar.
■
Pull Set Knob out while pressing Lock Release Lever.
・
When pulling Set Knob out, backing paper completed will be pulled out
together and will be removed from Backing Paper Release Bar.
■
Remove backing paper.
■
Pull Set Knob into the original position until it sounds clicking.
■
Please refer to "Label Set" on the page 6.
■
Press Auto/Manual BUTTON longer time and display L Mode and select
the registered length.
■
Revert to the mode that you have used.
■
Press START BUTTON and label will come out.
・
LED will change from flashing to lighting.
■
Keep pressing FWD BUTTON in order to wind new label roll into Backing
Paper Release Bar.
■
Pull Set Knob out while pressing Lock Release Lever.
・
When pulling Set Knob out, backing paper completed will be pulled out
together and will be removed from Backing Paper Release Bar.
■
Remove backing paper.
■
Pull Set Knob into the original position until it sounds clicking.
■
Please refer to "Label Set" on the page 6.
■
Please refer to "L Mode (Label Setting Mode)" on the page 8.
■
As depend on the terms of use, please follow the instruction for each mode
setting.
■
Press START BUTTON and label will come out.
In the case of setting the defferent kind of label roll
10
Notice:
In the case of setting label with L mode, remove label and press START
BUTTON after pressing FWD BUTTON in order to feed label, which the
numerical value will be registered.
In the case of using the same label continuously, press FWD BUTTON
in order to feed label until it passes Label Holder.
Take the registered numerical value back after pressing Auto/Manual
BUTTON longer time. Then remove label and press START BUTTON.
In the case of using with C mode and P mode, the counting number will
be increased by pressing START BUTTON even no label on the machine.
If you want to count the number continuously, please notice that you don't
press START BUTTON by mistake when setting the new label roll.
Feed the backing
paper
Remove backing paper
Set L-mode
Press start button longer
Indicate L
Set the label (See P.6)
Same kind of label roll
Revert to the
resistered length
Press Auto/Manual
Button longer
Select the mode
Select the mode
Label will come
out
Label will come
out
Different kind of
label roll
Set the L-mode (See P.8)
Press longer and
select the mode
Press longer and
select the mode
Wind backing paper
which is finished
using into Backing
Paper Release Bar
