Yaesu FTM-350 - APRS, Operating Manual

Page: 26 / 60

FTM-350 S
ERIES
O
PERATING
M
ANUAL
24
GPS O
PERATION
(
R
EQUIRES
O
PTIONAL
GPS A
NTENNA
U
NIT
)
When the optional FGPS-1 or FGPS-2 GPS Antenna Unit is installed, the transceiver
permits the display of your position (Longitude/Latitude).
Before beginning GPS operation, enable the “GPS” page via the Set Mode item “
C01
DISPLAY SELECT ” in the “ DISPLAY ” group. See page 35.
1
Press the [ FWD
] or [
BCK
] key repeatedly, until the “GPS” Page appears.
Your current position (Longitude/Latitude) appears at the upper right of the display,
and your current altitude and vehicle speed appears at the lower right of the display.
Additionally, your course direction (compass) displays in the left half of the display.
2
Press the [ DISP
] key to change the compass. Available selections are “Compass Rose
(North Up)”, “Compass Rose (Heading Up)”, and “Compass Tape”.
3
Press the [ POINT
] key to store the current position and date into the “Point” memory,
if desired. Available “Point” memories are in four groups, and there are four Channels
for each group.
4
Press the [
P LIST
] key to open the “Point” memory list. Rotate the
left side [
DIAL
]
knob to scroll the list and press the [ BCK
] key to close the list. You may delete an
unwanted point from the “Point” memory list by pressing the [ DEL
] key, if desired.
To return to the “Radio” page, press the [
FWD
] or [
BCK
] key repeatedly, until the “Radio”
Page appears.
You may change the measurement units of the altitude and vehicle speed via Set Mode item
“
G10 UNIT SELECT ” in the “ SYSTEM ” group (see page 42), and also change the time
format via Set Mode item “ I02 DATE&TIME FORMAT ” in the “ TIMER/CLOCK ”
group (see page 44).
: The
FGPS-2 GPS Antenna Unit requires CT-133 GPS Antenna Cable and CT-136
GPS Antenna Adapter.
1
3 4 2 4