Yaesu FTDX-9000MP, Operation Manual

Page: 155 / 180

Page 153 FT
DX
9000MP O
PERATION
M
ANUAL
MMMMM
ENU ENU
ENU ENU
ENU
M M M M M
ODE ODE
ODE ODE
ODE
057. CW FREQ DISPLAY
Function : Frequency Display Format for the CW
mode.
Available Values : DIRECT FREQ/PITCH OFFSET
Default Setting : PITCH OFFSET
DIRECT FREQ: Displays the receiver carrier fre-
quency, without any offset added.
When changing modes between
SSB and CW, the frequency display
remains constant.
PITCH OFFSET: This frequency display reflects the
added BFO offset.
058. PC KEYING
Function : Enables/disables CW keying from the
“DATA IN” terminal on the rear panel’s PACKET jack
while operating on the CW mode.
Available Values : DISABLE/ENABLE
Default Setting : DISABLE
059. QSK
Function : Selects the time delay between when the
PTT is keyed and the carrier is transmitted during
QSK operation when using the internal keyer.
Available Values : 15/20/25/30 msec
Default Setting : 15 msec
MODE-DAT G
ROUP
060. DATA IN SELECT
Function : Selects the data input to be used on the
PKT mode.
Available Values : DATA/PC
Default Setting : DATA
DATA:Uses the data input line which is connected to
the rear panel’s PACKET jack while using the
PKT mode.
PC: Uses the data input line which is connected to
the rear panel’s
AUDIO IN jack while using the
PKT mode.
061. DATA GAIN
Function : Sets the data input level from the TNC to
the AFSK modulator.
Available Values : 0 ~ 255
Default Setting : 128
062. DATA OUT
Function : Selects the receiver to be connected to
the data output port (pin 4) of the PACKET jack.
Available Values : VFO-a/VFO-b
Default Setting : VFO-a
063. DATA VOX DELAY
Function : Adjusts the “VOX” delay (receiver recov-
ery) time on the PKT mode.
Available Values : 30 ~ 3000 msec
Default Setting : 300 msec
064. DATA VOX GAIN
Function : Adjusts the “VOX” gain on the PKT mode.
Available Values : 0 ~ 255
Default Setting : 128
MODE-CW G
ROUP