Yaesu FTDX-9000MP, Operation Manual

Page: 129 / 180

Page 127 FT
DX
9000MP O
PERATION
M
ANUAL
The memory system of the FT
DX
9000MP allows storage and recall of up to 99 memories, each storing frequency, mode,
and a wide variety of status information detailed previously. Memories may be grouped into as many as six Memory
Groups, and additionally you get nine pairs of band-limit (PMS) memories along with five QMB (Quick Memory Bank)
memories.
M
EMORY
S
TORAGE
1. Set the Main (VFO-A) band up with all frequency,
mode, and status the way you want to have it stored.
2. Press the [ A
X
M
] button momentarily (the current
channel number will start blinking); the contents of
the current memory channel will be shown on the Sub
(VFO-B) display field.
3. Press the [ MCH/GRP
] key momentarily.
When you press the [ MCH/GRP
] key, the Red LED
imbedded within the switch should light up, indicat-
ing that you are ready to choose a channel into which
to store the data.
A A A A A
D D D D DVICE VICE VICE VICE VICE
:
If the Red LED imbedded in the [ MCH/GRP
] key does
not light up, check to be sure that the orange lamp to
the right of the [
CLAR/VFO-B
] knob is not illumi-
nated. It it is, press the [ A/B
] switch to make it go out,
then press the [ MCH/GRP
] key again.
M M M M M
EMOR EMOR
EMOR EMOR
EMORYYYYY
O O O O O
PERA PERA
PERA PERA
PERATION TION
TION TION
TION
[CLAR/VFO-B] Knob [A X M] Switch
4. Rotate the [ CLAR/VFO-B
] knob to select the memory
channel onto which you wish to store the data. If you
have selected a channel on which data is already stored,
that frequency will appear on the Sub (VFO-B) band’s
frequency display field.
5. Press and hold in the [ A X M
] key for two seconds to
store the frequency and other data into the selected
memory channel. A double beep will confirm that you
have held the [
A
X
M
] key in long enough.
[A/B] Switch
[MCH-GRP] Switch
VDD TEMP SWR BIAS