Yaesu FTDX-9000MP, Operation Manual

Page: 150 / 180

Page 148 FT
DX
9000MP O
PERATION
M
ANUAL
MMMMM
ENU ENU
ENU ENU
ENU
M M M M M
ODE ODE
ODE ODE
ODE
DISPLAY G
ROUP
013. TFT COLOR
Function : Selects the TFT color.
Available Values : COOL BLUE/CONTRAST BLUE/
FLASH WHITE/CONTRAST UMBER/UMBER
Default Setting :
Unmber Display Color: UMBER
Light Blue Display Color: COOL BLUE
014. DIMMER-METER
Function : Setting of the meter brightness level when
“DIM” is selected.
Available Values : 0 ~ 15
Default Setting : 4
015. DIMMER-VFD
Function : Setting of the frequency and TFT display
brightness level when “DIM” is selected.
Available Values : 0 ~ 15
Default Setting : 8
016. BAR DISPLAY SELECT
Function : Selects one of three parameters to be
viewed on the Tuning Offset Indicator.
Available Values : CLAR/CW TUNE/VRF- μ TUNE/
NOTCH
Default Setting: CW TUNE
CLAR: Displays relative clarifier offset.
CW TUNE: Displays relative tuning offset between
the incoming signal and transmitted
frequency.
VRF- μ TUNE: Displays the peak position of the VRF
or μ TUNE filter.
NOTCH: While you rotate the [ NOTCH
] knob,
the center frequency of the IF NOTCH
feature will be indicated.
017. ROTATOR START UP
Function : Selects the starting point of your
controller’s indicator needle.
Available Values : 0/90/180/270°
Default Setting : 0°
018. ROTATOR OFFSET ADJ
Function : Adjusts the indicator needle precisely to
the starting point set in menu selection 017.
Available Values : –30 - 0
Default Setting : 0
019. RIGHT TX METER
Function : Selects the Sub meter function
Available Values : ALC/VDD
Default Setting : ALC
ALC: Indicates incoming signal strength on the Sub
band (VFO-B) while receiving, and indicates
the ALC (Automatic Level Control) operating
range while transmitting.
VDD: Indicates the Vdd (final amplifier drain voltage)
at all times.
020. QMB MARKER
Function : Enables/Disable the QMB Maker (White
arrow “ V ”) to display on the Spectrum Band Scope.
Available Values : ENABLE/DISABLE
Default Setting : ENABLE
021. MY SCREEN
Function : Programs a TFT display (option) or an
external monitor operation page to be skipped while
selecting bands using the [
8/21
](
DISPLAY
) key.
Available Values : MAP / RF SCOPE / AF SCOPE /
LOGBOOK / SWR / ROTATOR / MCH LIST
To program the “page” to be skipped, rotate the
[
CLAR/VFO-B
] knob to recall the “page” to be
skipped, then press the [ ENT
] key to change this set-
ting to “ON.” Repeat the same procedures to cancel
the setting (skipped “off”).
022. LEVEL INDICATOR
Function : Enables/Disables the Sub band (VFO-B)
frequency display to show each frequency or value
while each of the enabled knob is turned.
Available Values : PITCH / SPEED / CONTOUR /
NOTCH / DNR / CW DELAY / VOX DEALAY
To disable the “function,” rotate the [
CLAR/VFO-B
]
knob to recall the “function” to be disabled, then press
the [
ENT
] key to change this setting to “OFF.” Re-
peat the same procedures to enable a function (set-
ting it to “ON”).