40
FT-7800R O
PERATING
M
ANUAL
The
FT-7800R
allows you to scan just the memory channels, the entire operating band, or
a portion of that band. It will halt on signals encountered, so you can talk to the station(s) on
that frequency, if you like.
Scanning operation is basically the same in each of the above modes. Before you begin, take
a moment to select the way in which you would like the scanner to resume scanning after it
halts on a signal.
Setting the Scan-Resume Technique
Three options for the Scan-Resume mode are available:
BUSY
: In this mode, the scanner will halt on a signal it encounters. Two seconds after the
carrier has dropped because the other station(s) ceased transmission, the scanner
will resume.
TIME
: In this mode, the scanner will halt on a signal it encounters, and will hold there for
five seconds. If you do not take action to disable the scanner within five seconds, the
scanner will resume even if the stations are still active.
HOLD
: In this mode, the scanner will halt on a signal it encounters. It will not restart auto-
matically; rotate the
DIAL
knob to re-initiate scanning if you wish to resume.
To set the Scan-Resume mode:
1. Press and hold in the [
BAND
(
SET
)] key for 1/2 second to enter the Set mode.
2. Rotate the
DIAL
knob to select Menu #37 (
SCAN
).
3. Press the [
BAND
(
SET
)] key momentarily, then rotate
the
DIAL
knob to select the desired scan-resume mode.
4. Press the [
BAND
(
SET
)] key momentarily to save the
new setting, then press and hold in the [
BAND
(
SET
)]
key for 1/2 second to exit to normal operation.
Note: The default condition for this Menu Item is “BUSY.”
S
CANNING
