![background image](http://html2.mh-extra.com/html/yaesu/ft-60r/ft-60r_operating-manual_3128263038.webp)
FT-60R O
PERATING
M
ANUAL
36
4.
The scanner will then resume according to the Scan-Resume mode selected in the
previous section.
5.
To cancel scanning, press the
PTT
switch or [
V/M
(
PRI
)] key.
Programmed VFO Scan
1.
Select the VFO mode by pressing the [
V/M
(
PRI
)] key, if necessary.
2.
Press and hold in the [
BAND
(
BAND DN
)] key for one second, then rotate the
DIAL
knob to select the bandwidth for the Programmed VFO scanner.
Available selections are ±1 MHz, ±2 MHz, ±5 MHz, ALL, PMS-
X, and BAND.
ALL
:
The scanner will sweep all frequencies.
PMS-X
: The scanner will sweep frequencies within the currently-selected PMS fre-
quency pair. See page 40 for details.
BAND
: The scanner will sweep frequencies only on the current band.
3.
Press the [
BAND
(
BAND DN
)] key momentarily to save the new setting and exit to
normal operation.
4.
Press and hold in the [
V/M
(
PRI
)] key for one second to start scanning.
5.
If and when the scanner encounters a signal strong enough to
open the squelch, the scanner will halt temporarily; the decimal
point of the frequency display will blink during this “Pause”
condition.
6.
The scanner will then resume according to the Scan-Resume mode selected in the
previous section.
7.
To cancel scanning, press the
PTT
switch or [
V/M
(
PRI
)] key.
1) When you start the Programmed VFO Scanner, the FT-60R will be chang-
ing frequency in the upward direction. If you want to change direction of the
scan while it is underway, rotate the DIAL knob one click in the opposite
direction (in this case, one click counter-clockwise). You’ll see the scanner turn around
and change frequency downward!
2) You may change the scanner’s method of operation so that the VFO frequency will
jump to the low band edge of the
next
band when the VFO frequency reaches the high
edge of the
current
band (or vice versa). See page 78 regarding Set Mode Item 54: VFO
.BND.
S
CANNING
VFO S
CANNING