VI. LED Signals
The Gateway is equipped with two LEDs (green and yellow) shown on Figure 1
at Section I.
The network LED (yellow) indicates Ethernet activity (including service messages)
and chaotically flashes at least once every few seconds. A constant signal from
the network LED means that there are physical connection problems (network cable
is unplugged, etc.), see Section II.2 for details.
This Section below describes signals of status LED (green) which indicates Device’s
state. After the power on, Device immediately produces two flashes once to indicate
that it is powered on.
Figure 1. Example of flashing sequence
During normal operation, the status LED fires two series (see Figure 1) of flashes every
8 seconds. The first series takes 1.5 seconds and consists from one to four flashes
and indicates the Ethernet mode (see Section III.3), see the Table on the next page.
— 32 —
Summary of Contents for YDEN-02 Series
Page 19: ...Figure 2 Gateway server settings 19...
Page 28: ...Figure 3 Filter configuration page 28...
Page 59: ......
Page 60: ......