How to use each mode
How to use each mode
4
Apply the treatment window fully and
firmly onto the skin (white READY
lamp will be lit) and glide the device
over the skin to carry out a treatment.
・
Once the white READY lamp is lit, flash emission can
commence.
・
By rolling the roller over the skin, flash pulses will be
discharged continuously.
・
The meter indicator lets you know how many more
flash pulses remain. When there are zero flash
pulses remaining, you will be able to resume
discharging flash pulses once the meter indicator is
replenished.
* Do not look directly into the treatment window of
the lamp head.
* Hold the device in a manner that does not block
the vent holes. Failure to comply may cause the
device to generate heat.
* Each time the level is raised, the interval
between each row of flash pulses will gradually
lengthen.
* When a flash pulse does not discharge, treatment
window is not firmly in contact with the skin. When
applying the device to the skin, make sure that the
white READY lamp is lit.
6
Moisturize skin treated with flash pulses using skin toner or mois-
turizing lotion.
5
When the treatment is finished, hold down the power/level button
(approx. 3 seconds) to turn off the device and let it cool down for
approximately 3 minutes.
・
Even if you do not press the power/level button, the device will automatically shut off after an
extended buzzer sound is emitted twice after approximately ten minutes of use.
・
Turn off the power and leave the device alone for approximately 3 minutes. The working fan will
cool down the lamp head.
7
After using the device, unplug the AC adapter from the wall outlet,
disconnect the adapter plug from the device, and clean the device
and lamp head.
・
Clean after each use according to “How to clean” (page 23).
・
Refrain from taking a bath (shower is permitted), exercising, or drinking alcoholic beverages on the
day of a treatment.
20
19
How to use the single mode
1
Insert the adapter plug into the
p o r t o n t h e d e v i c e f o r t h e
adapter plug and insert the AC
adapter into a wall outlet.
4
Press the power/level button and
select the level and usage site (BODY
or FACE).
・
There are three flash levels corresponding to the single
FACE mode and five flash levels corresponding to the
single BODY mode.
・
Each time the button is pressed, levels and usage sites can be adjusted as follows:
・
Start using the device from level 1 and gradually raise the level one by one until it gets to the level
appropriate for yourself. Do not use the device at a high level right from the outset (see page 16).
・
When the meter indicator (7 bars) is full, a beeping sound will be emitted to indicate that
preparations for flash emission are complete.
* Each time the level is raised, the interval between each flash pulse will gradually lengthen.
Single FACE mode /
Level 1
→
2
→
3
Single BODY mode /
Level 1
→
2
→
3
→
4
→
5
3
Hold down the power/level button
(approx. 3 seconds) to turn on the device.
・
“FACE 1” will be indicated in the indicator panel, which
means that the device is set to level 1 in single FACE
mode.
・
If the device is turned on, the internal fan will begin to
operate with a humming sound. This is not a malfunction.
2
Bend the grip on the device.
* Do not forcefully bend the device.
Attention
Make sure FACE mode is used when treating your face.
Using BODY mode may cause a burn injury or other problems.
Flash button
READY lamp
Level
indicator
Meter
indicator
Grip
Adapter plug
Power/level
button
※
Do not treat the same site twice or more times per day.
Roller
Glide slowly
(about 1 cm per
second)
