V1.2
P 24
Activate " Setting" > "Printer Settings" >
"Maintenance" > "Clean Nozzle".
Select “Clean Nozzle” function, and brush the molten filament and dust from the detecting pin while the extruder is
heated up.
Clean the detecting pin with the copper brush
• Turn clockwise to raise, turn counterclockwise to lower.
• Adjust screw a and b may offset the diagonal. (e.g. Left turn screw b will lead to the descendant of point 2.)
• Tuning the screw for a full circle will change the value by 0.5. A single push to the screw will change the
value by 0.2 to 0.25.
• Adjust the values to the 2.3-2.6 range.
• 3 values should be no more than ±0.2 from each other.
1.The value indicates the height of point
P1
,
P2
,
P3
; greater value indicates the higher the detected point is.
2. Turn the 3 turning screws at location "a", "b", "c" under the print bed to level the platform.
5.Clean the detecting pin
6.Level the print bed
When finishing the adjustment, repeat the calibration from step 2 until it shows "Calibration Completed".
Clean the 3 measurement points
How to adjust
:
Thumb of rules:
Specifications
P2
P3
P1
Model Name
da Vinci 1.1 Plus 3D Printer
Print Technology
Fused Filament Fabrication(FFF)
Print Head
Single Head
Build Volume
(W x D x H)
20 x 20 x 20 cm
Layer Resolution
Setting
Standard 200 microns
Speed 300 microns
Ultra fast 400 microns
Custom 100-400 microns
Filament Diameter 1.75mm
Nozzle Diameter
0.4mm
AC Input
100-127V~ 4.0A 50/60Hz
200-240V~ 2.0A 50/60Hz
Connectivity
USB 2.0
WiFi
LAN
USB Flash Drive
Display
5" TFT LCD
Control Method
Touch Panel
Indicator
Speaker
Weight
27 Kg
