MAINTENANCE
DESOLDER TIP REPLACEMENT AND DRESSING
Desolder tips can be changed or replaced simply unscrewing the barrel nut assembly.
The station must be turned off and allowed to cool before this operation. If the system
Page.7
is left on without a tip in place, damage to the iron assembly may occur!
After removing the tip, blow out any oxide dust that may have formed in the tip
receptacle. Be careful not to get dust in your eyes. Replace the tip according to
Figures 3-9 and hand tighten the securing screw for the barrel nut assembly. Pliers can
be used to avoid contact with hot surfaces BUT SHOULD BE USED WITH
CAUTION because over tightening may cause damage to the element or fuse the tip
to the element.
PROCEDURE FOR CLEANING CLOGGED TIPS
CAUTION: This procedure is to be working in high temperature. Be careful to avoid
burning your fingers during this operation.
1. Be sure that the spring wire (included) will not go through the nozzle of the
desolder tip.
2.
Adjust the heating element to a higher temperature allowing the clogged solder to
melt. Clean the tip by sliding the spring wire up and down until the passage is
clear. (See Fig. 3)
3.
Unscrew the barrel nut assembly as in Figures 4 & 5.
8
Summary of Contents for LF-8000
Page 14: ...13...
