DRAWING OF LF-8000
IMPORTANT
DESOLDERING
1.
Only activate the vacuum after the solder has completely melted. Melting is
accomplished by moving the hot tip around the lead leaving visible melted
solder on the component side of the P. C. B.
See Fig. 1 & 2.
2. Release the vacuum switch only alter the solder on the tip has been removed,
otherwise the tip may clog.
3. Add solder to the joint of the component and allow the solder to melt completely
for improved desoldering.
4. Remove the solder collector and clean it after no more than 200 applications.
However, daily cleaning is strongly recommended.
5. Replace the cotton pad in the solder collector and the in-line filter when they
begin to turn yellow.
6. If there is insufficient vacuum, use the spring wire included to clean the tip and
also check he in-line filters.
7. Be sure that all filters are in place during operation or damage to the vacuum
5
Summary of Contents for LF-8000
Page 14: ...13...
