14
Loading Film
Each roll of material comes with an extra 5 feet of material that allows for proper loading without
wasting the purchased material. Before starting the loading process, remove tray from the machine.
Step 1:
•
Match the colored dots on the end of each
supply roll with the corresponding dots on the
side of the machine. Note which roll is identified
as "top" and "bottom."
•
The "bottom" roll has a starter section.
•
Slide the supply rolls into the grooves in the
sides of the machine; making certain that the
roll is inserted completely.
Step 2:
•
On the bottom supply roll, grasp the
starter section by the leading edge.
•
Route over the bottom idler bar adjacent to the
lower rubber roller.
•
Make sure the starter film is inserted squarely
between the two rubber rollers.
•
Use the foot pedal to run the starter section into
rubber
rollers.
•
Ensure that the film is exiting under the cutter bar
assembly. (If not, refer to the "troubleshooting
tips" immediately following the load directions).
•
Run approximately half of the starter section into
rollers. Be sure not to advance any film with
adhesive exposed into the rollers!
WARNING! Equipment has pinch points that can cause injury. Keep hands, loose
clothing, jewelry or hair away from rollers during loading of the film.
Start the bottom leader between the rubber rollers
using the foot pedal
Insert the Top and Bottom roll as shown
