6
Cart Assembly Instructions
1.
The cart assembly is begun by assembly of the right side assembly frame end to the 2 cross bars [3346]
with a 2 ¼” Hex Head bolt
[3330]
with washer [2143-02] and split lock washer [2189-04]. Install the upper
cross bar by Inserting the metal dowel pin into the pilot hole and then inserting and locating the
threaded bolt into the screw hole. Tighten the bolt using the 3/16” Hex wrench for assembly [3352] and
then assemble the bottom cross bar. See figure 1 / 2. Then fit and assemble the cross bars to the left
side frame end in by inserting the metal dowel pin into the pilot holes of both the upper and lower cross
bars and tightening until secured.
2.
Once the cart frame has been assembled, turn the frame upside down in order to mount the caster
frames and caster wheels.
3.
The caster components [mounting frame, wheel and hardware are packaged together. See figure 3.
Figure 3: Caster components and hardware
Figure 1: Cross bars assembled one side at a time
Figure 2: Bolt with washer and lock washer
