51
10.4
Software parameters
In the following chapters all available parameters of the main and secondary menu
are listed. The upper window shows the factory setting and the line below the
possible range of settings.
The general parameter description is written for the
HYDROVAR MASTER Inverter
(Full
featured HYDROVAR including the high level control card which supports also the optional
modules like the optional Relay Card and all specific software features).
When using a
HYDROVAR SINGLE Inverter
(HYDROVAR with control card only for SINGLE
pump operation) there are less software features in comparison to the HYDROVAR MASTER
Inverter. All parameters which are not active for a HYDROVAR SINGLE Inverter are marked
with the following symbol:
…
Parameter not available for a HYDROVAR SINGLE Inverter
Parameters which are transferred automatically within the whole group of HYDROVAR units
are marked with the following symbol:
…
Global parameter (interchanged on all HYDROVAR within one system)
NOTICE! All changes will be saved automatically especially in case of a disconnection
of the power supply!
00
00 MAIN MENU
The 1
st
window, REQUIRED VALUE [02] and EFFECTIVE REQUIRED VALUE [03] depend on
the selected mode which has been chosen with parameter MODE [0105]. The differences
within the windows in the different modes are shown below:
a) Active MODE [0105] = Controller (Default setting)
XYLEM XX.X Hz
STOP X.XX Bar
1
st
display at mode Controller
This window shows the status of the HYDROVAR.
ON
Automatic and external released
Stop of the HYDROVAR by pressing
▼
STOP Manually
stopped
Start of the HYDROVAR by pressing
▲
OFF
External release (X3/7-8) is open
To start up the HYDROVAR close external
release or bridge terminal X3/7-8
S
G
