5019T Flat Panel Industrial Touch Monitor Chapter 2 – Installation
5
143627(A)
Unpacking the Unit
When you remove the 5019T from its shipping box, verify that you have the
parts listed below. Save the box and inner wrapping in case you need to
reship the unit.
•
5019T unit
•
Installation Fasteners (16)
•
Cables:
VGA cable, 10 ft. (3 m), and
RS-232C Cable, 10 ft. (3 m) for RS-232C touch option, or
USB Cable, 10 ft. (3 m) for USB touch option
Ground strap
•
Documentation and Support Library CD-ROM, which contains this manual
and all drivers required by this unit.
Quick Startup
This section gives you the steps to get the system up and running without
explaining the capabilities and options.
Warning
Remove power from the unit and disconnect the power cord before
making any adjustments to the inside or outside of the monitor.
Warning
For Hazardous Locations installation, review
Hazardous Locations
Installation
in Chapter 2 before startup.
To prepare the system for use, perform the following steps.
1. Attach the appropriate touch cable (USB or RS-232) if your monitor was
ordered with the touch option, following the instructions in Chapter 2.
2. Attach the power cord from the power receptacle to a properly grounded
100-240 V AC, 50-60 Hz, or an optional 18-30 V DC power source. (See
System Power
in Chapter 2 for more information.)
3. Turn on power to the 5019T (via an outlet power switch if applicable).
Then turn on power to the host computer. The system will boot up into the
operating system.
4. If the unit is equipped with a touch screen, install drivers on the host
computer via the floppy, the CD-ROM, or the network, as applicable.
