27
5.5.2 Motion Alarm
Motion includes two sub menus: motion and schedule. The steps to set motion alarm are as
follows:
①
Go to Main Menu
Setup
Alarm
Motion
Motion tab. Refer to Fig 5-19.
②
Enable motion alarm, set alarm hold time which refers to the time till which the system
will wait for further detection of motion. e.g. If the holding time is set to 10 seconds,
once the system detects a motion, it will go to alarm but would not detect any other
motion alarm (specific to channel) until 10 seconds. If there is other motion detected
during this period it is considered as continuous movement, otherwise it will be
considered as a single motion.
Fig 5-19 Alarm Configuration-Motion
③
The setup steps of motion trigger are similar to “Alarm Handling” (See Chapter 5.5.1
Sensor
Alarm Handling setting for more details).
④
After clicking Area button, a dialog box will pop up as Fig 5-20.
Fig 5-20 Motion-Area
⑤
In the Area interface, you can drag slide bar to set the sensitivity value (1-8). The higher
the value is the more sensitive it is to motion. Since the sensitivity is influenced by color
and time (day or night), you can adjust its value according to the practical conditions.
Left click the grid and drag to delete area. Click
icon to set the whole area as
