Loosen the fastening nut of the
upper
triple
clamp
Remove
upper
triple clamp
Grease the steering head bearing of the
preassembled XTRIG triple clamp with
suitable bearing grease
Place the upper
triple clamp and
tighten
the
adjusting nut
(4)
by hand
NOTE: only now the lower triple clamp can
be released
Insert fork
including front wheel and brake
system into the triple clamp
WARNING:
now
tighten
only
the
bolts
M8x40
(9)
of the upper triple clamp with a
torque of 17 Nm.
Set the required bearing
clearance
with the adjusting nut
(4)
Loosen the clamps of the
upper
and lower
triple clamp
Hold the lower triple clamp and remove the
adjusting nut
of the steering head bearing
Slide the lower triple clamp into the steering
head while holding the upper steering head
bearing and sealing washer
NOTE: Do not
release
t
he lower triple
clamp, continue to p
ress
in the direction of
installation
Pull out fork together wit
h
front wheel and
brake system downwards
Dismantle
the lower triple clamp. Clean the
steering head and bearing seat of the
motorcycle
Depending on the model,
install
the seal for
the steering head bearing (sealing
ring
or
O–ring)
MOUNTING THE XTRIG ROCS PRO TRIPLE CLAMP:
REMOVING THE FACTORY TRIPLE CLAMP:
7
.
8
.
9
.
10.
10.
10.
10.
10.
10.
10.
10.
10.
10.
10.
10.
10.
10.
10.
10.
10.
10.
10.
10.
10.
10.
10.
10.
10.
10.
10.
10.
10.
10.
10.
10.
10.
10.
10.
10.
11.
12.
1.
2.
3.
4.
5.
6
.
