Chapter 6 – Operation
54 XR5919-A
Figure 6.8 – Fork Ratings
Because forks are always used in multiples, the total
rating of any combination of forks will be the sum of their
rated capacity. Other than block forks, all forks should
be used in matched pairs. Block forks should be used
in matched sets.
The maximum load capacity for this telehandler is 5,100
pounds (2,313.3 kilograms). The matched pair or set
of forks used on this telehandler should have total load
ratings which equal or exceed 5,100 pounds (2,313.3
kilograms). When the load rating of the telehandler dif-
fers from the load capacity of the forks, the lower value
becomes the overall load capacity.
Standard Carriage Operation
The standard carriage uses manually adjustable forks
and can be tilted up or down by using the thumb stick on
the control handle.
Figure 6.9 – Attachment Tilt Control Switch
Quick Attach System
This Telehandler includes a quick attach system that al-
lows for easy attachment changes. Perform attachment
connection and removal procedures on level ground.
Attachment Connection
Warning
Improper connection of an auxiliary attachment can
result in death or serious injury. Attachments not
locked into place could become unstable and fall on
the operator or other personnel near the Telehandler,
which could result in death or serious injury.
• Make sure attachment locking devices are always
in place.
• DO NOT operate the Telehandler until you have pos-
itive indication that the carriage attachment is fully
engaged.
1. Position the Telehandler directly behind the attach-
ment.
Note
Allow enough distance to extend the boom approximately
18 to 20 inches (0.4 to 0.5 meters).
2. Tilt the quick attach adapter forward.
3. Extend the boom and/or drive the telehandler forward
until the pivot pins are below and between the two
(2) attachment hooks.
Figure 6.10 – Pivot Pins
4. Raise the boom until pivot pins have seated fully in
attachment hooks.
Down
Up
Attachment Hooks
Pivot Pins
Summary of Contents for XR5919-A
