Xtool AnyCut KNC91, User Manual

Page: 8 / 31

6
INSTALL PROBE & CUTTER
1) Lift up the protection cover. Spin the right cylinder inside the cover until the screw hole is right in front of you.
2) Use the hex wrench to loosen the screws on the cylinders.
3) Take out the probe. Push it inside the slot of the left cylinder, until you can't push it further. Then tighten the screw of the
left cylinder.
4) Take out the cutter you need (1.5/2.0/2.5mm). Make sure the flat side of the cutter is on the same direction of the screw
hole and push it inside the slot of the right cylinder. Make sure the tip of the cutter is 3~5mm lower than the probe. Then
tighten the screw of the right cylinder.
5) Every time after installing probe or cutter, please turn on the machine, go to settings and calibrate the probe and the
cutter.
6) To take out (or exchange) the cutter or probe, turn off the machine, loosen the locking screw and pull out them. When
pulling the cutter, take on a pair of gloves to avoid scraping your hands.
INSTALL JAW
1) Use the hex wrench to loosen the locking screw on the bench;
2) Take out the jaw, slide it inside the slot of the bench from the right side of the bench;
3) When the jaw is slided inside the bench, tighten the locking screw to lock the jaw from moving.
To uninstall the jaw, loosen the screw and slide the current jaw out. Then you can replace it with a new one.
1. Take the hex wrenches that come with the machine,
remove the screws that fixed the frame and pull the
frame out.
2. After that, take 2 screws that come with the
machine. Put them into the probe & cutter mounts and
replacing the screws that fixed the frame. Also install
the locking screw at the bottom back on the bench.