14
15
AC OUTLET
Your generator is equipped with an output indicator light.
When this light goes out and the red light glows, then the
generator will produce NO POWER.
To restart the power supply;
1. Remove the appliance. Check wattage, page 13 or data
label.
2. Press the Reset Button, Pic. 14.
3. Wait 15-20 seconds, the green light should glow and the
red light goes out.
NOTE: If the green light does not glow, then you will need to
stop the generator, go to step 7.
4. Re - attach the appliance.
6. If the output indicator light goes out and the red light
glows, the output power stops then the attached
appliance is either faulty or the appliance’s required
power is greater than the generator’s output, check the
appliances wattage requirements refer, Page 13.
7. Stop the generator, see page 12.
8. Wait 2 minutes.
9. Start generator, see page 11, ensure the green output
indicator light is illuminated.
10. Re - attach the appliance.
11. If the output indicator light goes out and the red light
glows, the output power stops then the attached
appliance is either faulty or the appliance’s required
power is greater than the generator’s output, check the
appliances wattage requirements refer, Page 13.
Output indicator light (green) will remain ON during
operation. However if it goes out and the red light comes
then you have overloaded the generator, see the following
and page 13.
1. Check that the only illuminated light is the green output
power.
2. Lift the flap and plug your appliance into the AC outlet
socket on the face plate.
3. Turn the appliance on and use as per the
manufacturers manual.
4. When finished turn your appliance off.
5. Disconnect appliance from the generator and the flap
should close automatically.
NEVER leave any appliances plugged into your generator,
always disconnect when appliance is not in use.
If the oil level in the motor sump drops to a dangerously low
level then the oil light, yellow, will flicker and the generator
will automatically stop.
If the oil level in the motor sump is dangerously low, then the
generator will not start, however the low oil light, yellow, will
flicker only when the recoil starter is pulled.
If your generator will not start always check the oil
level first.
To add oil or check the oil level, refer page 10.
USING THE AC OUTLET
SAFETY DEVICES
LOW OIL LIGHT
OUTPUT INDICATOR LIGHT
PIC. 14
