XSPC RayStorm, Manual

Page: 8 / 18

Cutting the Tubing
When you cut the tubing it's very important to get a straight clean cut. If you the cut is rough or uneven then it could stop
the tubing sealing and cause a leak. You might find it useful to buy a hose cutter instead of using scissors.
Attaching the Tubing (Barbed Fittings)
Cutting the Tubing
1. Push the end of the tubing over the barb. The tubing
is a tight fit, but this is necessary to avoid leaks. 2. Place a hose clip over the lower part of the barb and
press the two sides together fix the clip.
Attaching the Tubing (Compression Fittings)
1. Place the cap of the compression fitting over the
tubing.
3. Slide the cap over the fitting and rotate it clockwise
until the tubing is sealed in place.
2. Push the end of the tubing over the barb. The tubing
is a tight fit, but this is necessary to avoid leaks.
Page 7/16