XSPC RayStorm, Manual

Page: 12 / 18

Fitting the Waterblock (Intel 1366, 1156, 775)
1. Remove the plastic film from the base of the
waterblock.
4. Place a spring and washers over each bolt.
Bolt >Nut >Spring >Metal washer >Plastic Washer
3. Place the waterblock onto the CPU and line-up the
mounting plate with the holes on the motherboard.
5. Place each of the bolts through the mounting plate
and loosely screw into the backplate using the knurled
section of the bolt [A]. When all 4 bolts are loosely
fitted, tighten each bolt [A].
6. Use the lower knurled nut [B] to adjust the pressure
on the CPU. Make sure to apply equal pressure to
each spring.
2. Apply a thin layer of thermal paste to the CPUs heat
spreader.
Attaching the Pump
1. Push the pump back so the faceplate is flush with
the front of the case. Fix the pump in place by using
the small M3 screws.
2. If you have a case with quick release clips, we
recommend removing them and using the screw hole
underneath.
The installation process below is shown without the tubing connected. This has been done so the installation process
can be seen clearly, without any obstructions.
Page 11/16