XSPC RayStorm, Manual

Page: 5 / 18

Preparing the Radiator
Preparing the Pump
Preparing the WaterBlock
1. Remove the plastic plugs from the G1/4” ports
2. If you're using compression fittings, use a small coin
and rotate it clockwise until the o-ring is compressed.
3. If you're using barbed fittings, first hand tighten the
barb and finish by using an adjustable spanner. Do not
apply too much force as it may cause damage.
4. Using the 30mm 6-32 screws, attach a fan and fan
grill to the radiator. Be careful, using screws longer
than 30mm will puncture the radiator core.
1. Attach the fittings to the inlet and outlet of the pump.
Do not apply too much pressure as this can strip the
threads.
2. Push the 5mm LED into the LED holder. You might
prefer to do this after installing the kit.
2. Push the two 3mm LEDs into the LED holders. You
might prefer to do this after installing the kit.
1. Attach the fittings to the inlet and outlet of the pump.
Do not apply too much pressure as this can strip the
threads.
Page 4/16