XSPC RayStorm, Manual

Page: 10 / 18

Example Installation Walkthrough
1. Place the motherboard into the case and position
the radiator, pump and waterblock into there chosen
locations. You might want to try moving the
components around to find the best positions for
routing tubing.
2. Decide on the loop order and measure the length of
tubing for each connection. We advise leaving 5-10cm
of slack tubing for the connection to the pump. This will
allow you to pull the pump forward for filling and
topping up the coolant.
3. Connect the tubing and check all the fittings are sealed. In the photos above the loop order is pump > radiator > CPU
block > pump. When the tubing is connected you should make sure it doesn't have any kinks. Kinks will reduce the flow
rate and have a significant effect on performance.
4. You can now remove the motherboard from the
system ready for filling and leak testing.
Attaching the Radiator
1. Lift the radiator into position and line it up with the
screw holes on the case panel. 2. Use four 6mm 6-32 screws in each of the four
corner holes. Do not use screws longer then 6mm.
Page 9/16