Xplore 304, Manual

Page: 85 / 206

8-29
HOW TO USE YOUR CARAVAN’S EQUIPMENT
Indoor temperature shows the current temperature and
whether the circulation pump is active (O). Tap the icon to
change the desired temperature.
Zone icons (dual zones). Displays the current temperature and
whether the circulation pump is active in the zone (O). Tap the
icon to change the desired temperature.
Light*. Start, turn off, or dim the AC lighting (only with Truma AC)
Symbol description of the top row of the status screen (Fig. 4)
Energy. Shows the energy source used; the flame turns red
when gas is in use and the flash turns yellow when electricity is
in use. Tap the icon to select and prioritise energy source and to
set load monitor* and high altitude mode.
Hot water. Indicates whether hot water production is on, “boost”
or turned off . Press the respective controls to start/switch
off or increase hot water production. The thermometer fills up
entirely when the hot water reaches boost temperature. See Hot
water section.
Outdoor temperature*. If an outdoor sensor is installed, the
current outdoor temperature is displayed.
Fig 4. Main menus on
the Status screen
Set the desired temperature
The temperature can be set from +5ºC to 30ºC in increments of
0.5ºC. To set the temperature, press “Indoor” (single zone)/
”Respective zone” (dual zone). The temperature shown (Fig. 5)
reflects the temperature currently set.
• To raise the temperature, press the plus button to the right of
the temperature.
• Lower the temperature by pressing the minus button, to the
left of the temperature.
You can leave the menu by clicking the Back arrow in the upper
left part, or by pressing the “MENU” button once; the heating
system works directly to reach the set temperature.
WARNING:
Scalding Hazard
When the hot water and glycol mixture in the boiler are
heated at the same time, the hot water can become very hot
in the event of a significant heating requirement.
Hot Water
In the boiler there is a built-in water heater with a capacity of
about 8.5 litres. The boiler can be used even without fresh water
being in the heater. There are three different settings for hot water:
no hot water, normal operation and boost (prioritised hot water)
Fig. 6
• No hot water or normal operation. Press the on/off button on
the screen under hot water to switch between no hot water
production and normal hot water production.
Fig 5. Set temperature
Fig 6. Set up hot
water production