Xplore 304, Manual

Page: 43 / 206

6-7
GETTING STARTED
Whale High Flow Pump with
Intelligent Control
®
Your caravan has been fitted with the Whale
High Flow Pump with Intelligent Control
®
Water System
Before using you water system for the first
time, you must prime the water system and
calibrate the Watermaster Pump Controller.
Your water system has been fitted with the
technology to ensure you never have to
adjust your pressure switch again! Whale
High Flow Pump with Intelligent Control
® also
protects the life of your pump by
automatically turning it off if the water
container is empty.
To prime your Water System
Step One
Place pump into a full water container.
Ensure that the pump reaches the bottom of
the water container as shown.
Step Two
Open socket lid, by using the side grips as
shown.
Step Three
Insert plug and secure by using the socket lid
to lock in place.
Step Four
Adjust the dust cover so that it covers the
opening in the water container. This prevents
debris entering.
Please Note: The dust cover
must not be secured to the opening as air
must be able to enter the container.
Step Five
Switch on the Master Switch. This allows 12V
d.c. to reach the pump and it should start to
run.
Step Six
Open one cold tap. Trapped air will be
expelled from the system and water will flow
from the tap. Open all taps on cold then hot
to expel all air in the system.
Step Seven
Turn the tap off when water flows evenly. The
pump should turn off after approximately 10
seconds.