Xplore 304, Manual

Page: 144 / 206

8-88
HOW TO USE YOUR CARAVAN’S EQUIPMENT
Emergency Disarm
Insert the touch-key briefly into the socket.
The alarm will turn off.
Silent Arm and Disarm
(i) Press the small button briefly followed by
a press on the arm/disarm button.
(ii) The alarm will arm/disarm without chirps.
Sensors
Each caravan alarm is installed with a
Passive Infrared Detector (PIR) and a leg
sensor. Additional sensors can be purchased
from your dealer to enhance security.
Passive Infra Red Sensor
The wireless PIR sensor will detect
movement in the caravan and transmit a
radio signal to the alarm module, if the alarm
is on the siren will sound.
Leg Sensor
The leg sensor will detect the corner
stabilising leg being raised or lowered and
transmit a radio signal to the alarm. The leg
sensor is fully sealed against dust and water
and has a battery life expectancy of three
years. When the battery becomes exhausted,
the sensor will need to be replaced.
Enhanced Features Arming The
System In “At Home” Mode
In the ‘at home’ mode, any sensor that is
programmed to be isolated, such as the PIR
sensor will not trigger the alarm. Other
sensors, such as the leg sensor, will trigger
the siren. Arm as normal followed by a
second press on the arm/disarm button within
2 seconds. Normal “on” tone followed by “at
home” tone indicating isolation is active.
Settling time of 15 seconds before
responding to triggers. Armed in the isolation
mode will be indicated by a double flash
intermittently of the LED. The “at home”
sensors will be isolated; other sensors will
trigger the siren for 30 seconds.
Arming the System in Test Or Buzz
Mode
In the buzz mode the siren will sound a short
tone when a sensor is triggered instead of
sounding for 30 seconds. It is advisable to
test all the sensors.
PROTECT - AUTOWATCH ALARM
SYSTEM (WHERE FITTED)
Manufactured by Autowatch, The system is
designed to give years of trouble free
operation. Made with only the highest quality
components and using state of the art
technology you can be assured that your
caravan has the best electronic protection
available.
Each caravan alarm is installed with a
Passive Infrared Detector (PIR), a sensor that
detects movement in the caravan and
transmits a radio signal to the alarm module.
If the alarm is on the siren will sound. A leg
sensor, fully sealed against dust and water,
will detect if the corner stabilising leg is being
raised or lowered and transmits a coded
radio signal to the alarm.
Additional sensors can be purchased from
your retailer to enhance security.
See section below for operation or consult
the manufacturers instructions provided in the
Owners Information Pack.
Basic Operation Arming the System
(i) Briefly press (large) arm/disarm button.
(ii) Single chirp.
(iii) Awning light illuminates for 30 seconds.
(iv) Settling time of 15 seconds before
responding to triggers.
(v) Single intermittent flash of status LED
(every 2 seconds).
(vi) All sensors triggered will result in siren
sounding for 30 seconds, or until reset by
pressing the arm/disarm button.
Disarming the System
(i) Briefly press the (large) arm/disarm
button.
(ii) Double chirp.
(iii) Awning light illuminates briefly on and off
and then on again for 30 seconds.
(iv) LED off.
Panic Alarm
(i) Press and hold the small panic button on
the transmitter for two seconds.
(ii) The siren will sound for thirty seconds,
unless reset by pressing any of the
transmitter buttons.