20
“Xplore Your World!”
L. RESPOND™ CONTOURED HEAD SUPPORT (optional)
NOTE:
See section
V. S for Head Sup-
port configuration.
Attachment
1. 1. Insert screws through plastic mounting
bracket and metal head rest plate (fig.
49A). Using 1/8in Hex Wrench and 3/8in
Nut Driver, tighten nyloc nuts onto
screws (fig 49B)
2.
2. Thread webbing through 3-bar slide as
shown in Figure 50, then tighten until
head rest is tight against metal plate.
Adjustment
1. 1. To adjust the head rest rotationally
use a 5/32” Hex Wrench and 7/16” Nut
Driver to loosen screws as shown in
figure 51. Position head rest as de-
sired, and tighten screws so that head
rest doesn’t move.
2. 2. To adjust fore/aft position of the
headrest, use a 5/32” Hex Wrench and
7/16” Nut Driver to remove screws as
shown in figure 51. Position headrest
as desired, re-insert screws into new
holes and tighten.
Figure 49
Figure 50
A
B
Figure 51
A
B
1
2
3
4
Cam Lock Closed
Cam Lock Open
M. THERAPEUTIC TRAY (optional)
Tray Installation and Removal:
1. Align the two tray posts with the tray receivers on the chair and push the tray posts into the
receivers to the proper position (fig 52 A).
2. Pull the cam locks on both sides up until they lock into position (fig 53 B).
3. Remove the tray by releasing the cam locks and pulling the tray out of the receiver.
Figure 52
Warning: Tray must not be loaded with objects heavier than 11 lbs (5 kg).
Warning: Tray must be removed from chair during transport in a motor vehicle.
A
B
N.
GRAB BAR (optional)
1. Align grab bar with slots in arm rest
(fig. 54), then insert grab bar into slot.
2. Use cam locks to lock grab bar into
place (fig. 53 B)
3. To remove, unlock cam locks (fig. 53
A), then remove grab bar.
Figure 54
Cam Locks
Figure 53
A
B